Adding Beads to Rainbow Loom Bracelets

Rainbow Loom Bracelet with Beads

How to Make a Rainbow Loom Bracelet with added Beads and Charms

 

In this tutorial we will be showing you how to add beads into your Rainbow Loom Bracelets. For this example, we will add M-E-T-S to a triple single bracelet. If you do not know how to make a triple single, click here for instructions. For this pattern we used 2 looms so the bracelet looks the same on all sides. If you only want to use 1 loom that is fine.

 

 



http://www.youtube.com/watch?v=zjvhCIcICg4

We got the beads at Micheals, for around $4.00. Be sure to buy beads that have a whole in the middle! This is an entry level pattern and one of the most basic ways to add beading to Rainbow Loom Bracelets.

You are going to want to thread the bans through the center of the beads first. Make sure that there are pieces of the bands showing on both sides of the bead. After that, begin by laying down your first track around the out side of the loom. Once that row is complete. Place the beaded bands down the center of the loom.

Once you have the outside track and inside complete, you will need to add your triangles to close the bands. Start at the left end of the loom and work your way to the right, with the tops of the triangles pointing in the direction you are moving. Then you will need to start hooking just like any other triple single bracelet.

That is! Pull of your bracelet from the loom and enjoy!

Leave a Reply

Your email address will not be published. Required fields are marked *